Welcome Page Body
Welcome to the Remotes Support section. Here you will find informative videos and owner's manuals with instructions for installing and operating your Hunter irrigation remote.
Section Menu
Quick Start
Installation
-
Installation
Due to the rapid acceptance of the Hunter ROAM amongst Hunter Irrigation Products suppliers and end users, this Support Article is dedicated to the installation guidelines of our
Changing Address
-
Changing Address on ROAM Remote Transmitter
Both the ROAM Transmitter and Receiver have an “address” that they use when communicating. If the addresses do not match, the receiver will ignore the transmission. Your ROAM comes
-
Changing Address on ROAM XL Transmitter
Your ROAM XL System is pre-addressed to work right out of the box. However, if you changed the Transmitter address as described in the section, Preparing the Transmitter For Use",
Changing Max Station Number
-
ROAM - Changing the Maximum Station Number
Your ROAM Transmitter comes from the factory with the maximum station number set to 15. This means that when you use the UP and DOWN buttons to change the station, you may change
-
ICR - Changing the Maximum Station Output Number
Your ICR Transmitter comes from the factory with the maximum number of stations set to 9. This means that when you use the UP or DOWN buttons to change the station, you may change
Changing Mode
-
ROAM XL - Switching Modes and Changing Max Station Count
Turn the Roam XL unit on by pressing any button. The mode that should be set based on the controller model. XCORE model - RES Mode PRO-C/HPC model - RES Mode ICC2/HCC
HPC Panel Compatible
-
HPC Panel Compatible
The HPC face panel quickly and easily upgrades Pro-C® controllers (PC400 models manufactured since March 2014) to next-generation smart controllers via the Hydrawise platform.
Operation Videos
Troubleshooting
-
Reset Roam XL
Power must be removed from the transmitter by removing at least one AAA battery from the battery compartment on the back of the unit. Press both the On and Off buttons
-
ERR Messages
When using a ROAM, ROAM-XL, ICR, or SRR remote, you may come across a controller that gives you an ERR or SP ERR message. There are two reasons that would cause one of these